Rexroth A4FO Of A4FO40,A4FO71,A4FO125,A4FO180,A4FO250,A4FO500 Hydraulic Axial Piston Pump,Concrete Pump
Better parts company specialize in research and development,production and sales of hydraulic products.We have more than 8 years experience focusing on the overseas Market.
Our main products is hydraulic pump,motor,valve,gear box ,gear pump,spare parts,ect.Involved in hydraulic brands:Rexroth,Parker,Eaton-Vickers,Linde,Sauer-Danfoss and so on.We always adhere to the "High Quality,best service,competitive price ”product concept.
Welcome new and old customers from all over the world to contact us for future business relationship and mutual sucess
 | SERIES | A4FO series axial piston quantitative pump |
| SPECIFIION | 16,22,28,40,71,125,250,500 |
| Series 1,Series 3 |
| WORKING PRESSURE | Rated pressure 40MPa, peak pressure 45MPa |
| | FEATURE | -Swash plate A4FO axial plunger quantitative pump for hydraulic transmission in open loop
- Flow rate is proportional to drive speed and displacement
- Excellent oil absorption performance
- Very low noise
- Long service life
- Combination pumps are allowed |
Safety instructions
The pump housing must be filled with hydraulic oil (injected into the housing cavity) during startup and operation. Must start at low speed without load until the system is completely empty.
When parked for a long time, the shell can be drained through the working pipeline. When restarting, ensure sufficient oil is injected into the housing.
The minimum suction pressure of the oil port S shall not fall below 0.8 bar.
Installation position
The axis is horizontal at the bottom. When installed on the tank, do not allow the installation position of "shaft horizontal, oil suction toward the bottom"!
Install below tank level
Pump position below minimum oil level in tank (standard)
Add an axial piston pump before starting by going through the uppermost oil drain of the housing
Suggestion: Add suction tube
Run the pump at a low speed (ignition speed) until the pump system is fully filled
The minimum submersion depth of the suction or drain line in the tank: 200 mm (relative to the lowest oil level in the tank).
Install above tank level
A pump installed above the lowest oil level in the tank
The installation position is lower than the oil tank level
The installation position of "the shaft is against the top" and "the shaft is level and the oil suction mouth is at the bottom" is not allowed (when the pump housing stops, it leaks oil through the suction pipe).
Note: - The maximum allowable straw length hmax = 800 mm
- Minimum allowable pressure of oil port S (minimum oil suction pressure)
Product Tags:
|
|
High Pressure A4FO Series Rexroth Hydraulic Pump A4FO40 A4FO71 A4FO125 A4FO180 A4FO250 A4FO500 Images
|
